Comparison of Surface Irrigation Simulation Models: Full Hydrodynamic, Zero Inertia, Kinematic Wave

Mohammad Valipour

Abstract


Some phenomena such as surface irrigation are so complex that it is very difficult to implement them in nature. For this purpose, simulation models are used. In this study, ability of full hydrodynamic, zero inertia, and kinematic wave models has been investigated in surface irrigation simulation. Using SIRMOD software, their performance has been compared. The results showed that full hydrodynamic and zero inertia models were very powerful in simulation process. For increasing of filed slope until amount of 0.01 full hydrodynamic and zero inertia models had not any difference but for more increasing of S0 due to the increasing of velocity, accuracy of zero inertia model dropped. In full hydrodynamic and zero inertia models for increase in Manning’s roughness coefficient amount of error was increased until n=0.15. After this amount, error remained constant thus n=0.15 determined as critical discharge. Accuracy of kinematic wave model reduced in clay and heavy clay soils, high discharges, high Manning’s roughness coefficient, and basin irrigation. However, in many situations all three models had the same answers and were capable tools to simulating of surface irrigation processes.


Full Text: PDF DOI: 10.5539/jas.v4n12p68

Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

Journal of Agricultural Science ISSN 1916-9752 (Print) ISSN 1916-9760 (Online)

Copyright © Canadian Center of Science and Education

To make sure that you can receive messages from us, please add the 'ccsenet.org' domain to your e-mail 'safe list'. If you do not receive e-mail in your 'inbox', check your 'bulk mail' or 'junk mail' folders.