Two-Stage Approach for Improving the Thickness Distribution in Superplastic Forming


  •  Reem Jafar    
  •  Firas Jarrar    
  •  Naser Al-Huniti    

Abstract

Superplastic Forming (SPF) process has many unique advantages over conventional forming operations including ability to produce complex thin shapes and significant cost and weight savings potentials. However, the SPF may result in excessive thinning at certain locations and a non-uniform thickness profile. To address these issues, the two-stage SPF process was developed to improve the uniformity of thickness distribution. In this work, two techniques were considered to improve the final thickness distribution of a complex shape, namely, the license plate pocket potion of an automobile decklid outer panel. These two techniques are the reverse free bulging and sheet preforming. The commercial finite element code, ABAQUSTM, was used to model the two-stage SPF process of an aluminum alloy AA5083 sheet at 450 °C. The study concluded that reverse free bulging did not result in improvements in the thickness profile compared with that obtained from the single-stage SPF. However, the sheet preforming technique, with an engineered preform cavity, resulted in an almost uniform thickness distribution for the superplastically formed part.



This work is licensed under a Creative Commons Attribution 4.0 License.
  • ISSN(Print): 1927-0585
  • ISSN(Online): 1927-0593
  • Started: 2012
  • Frequency: semiannual

Journal Metrics

Impact Factor 2022 (by WJCI):  0.583

Google-based Impact Factor (2021): 0.52
h-index (December 2021): 22
i10-index (December 2021): 74
h5-index (December 2021): N/A
h5-median (December 2021): N/A

Learn more

Contact